I need to control from one to four fuel injectors, these will be controlled by a potentiometer (throttle regulation)
problem is injectors are 12v and I need to control voltage per cycle and duration of it to vary fuel delivery to engine.
board, Arduino nano
-fuel delivery control for 4 injector
-injectors from min5v up to 12v (fully open) and control of injection time (voltage vs time)
-termistor/temperature sensor to condition when it should work and when cold not to work
20 freelancers are bidding on average €48 for this job
Dear sir I have more than 10 years experience in embedded systems design and i can do the fuel control please check my profile also please message me so that we can discuss
Hello Client I have seen ur project details and i believe that i can do ur task efficiently and within time span u r providing i am electronic engineer, kindly review my profile and then decide
hello i am a computer engineer,i have masters in computer engineering,i have experience for more than 7 years in arduino and electronics i can help in implementing ur fuel controller
Hello I can solve your issue. I am an Electrical Engineer and I work on Embedded hardware and Electronics Hardware design. Please contact me and elaborate your project and problem so that we can discuss. Thank you
hello, I am CDI(capacitive discharge ignition) designer. i think your project is similar to CDI on the timer. but I need the specification of the injector you are using. thanks
hi,dear. i read your description. i have some experience in 2 years. you will can discuss your project with me anytime. i want to work for your project with my skill. regards.