Design and test circuit prototype based on a proof of concept

Предложение еще не подано

I can work for you. .

I am an electronic engineer with 4 years of experience. I can work on this project and provide u with proof of concept. I have at my disposal several instruments that will be useful ib such experimental work. please contact me to discuss details

La propuesta todavía no ha sido proveída

I have over ten years experience in the designing, manufacturing and implementing of electronic devices.

I am Embedded System Design and Development Engineer. I have expertise in Microcontroller Programming and development on AVR (ATmega and ATtiny), Arduino and ARM (Cortex M0 and Cortex M4) in C/C++/Assembly Language. I have done - Control of DC motor, Display on LCD and input from Hexpad - RFID Based Factory Automation and Remote Inventory Management. - RFID Based Loyal Card for Loyal Customers. - Bluetooth Communication between MCU and RFID Host. - Vehicle Tracking using GPS and Accelerometer. and a lot more. I have expertise over all communication protocols of Microcontroller: - SPI (Master/Slave) - UART - USART - I2C (Master/Slave). - Ethernet - Wifi - Bluetooth etc.. I am expert in interfacing sensor modules with microcontroller. I believe in providing superb quality provided that the deadlines are met. Moreover, during the course of my project I would keep you updated regarding the status. Looking forward to hear from you Regards Khawaja Muhammad Abdur Rehman

A proposal has not yet been provided

Hello, I can help you make and test your design, but you have to give me more information about it. This is about me: I have 8 years of product design in the automotive industry. I am an expert in: - Dc - Dc converters - USB charging - accelerometers, gyroscopes - GPS and GSM - LCD Displays - LED power calculation As a Layouter I have 5 Years experience. I am an expert in : - Power Dissipation Calculation - EMC Rules - Impedance Calculation - Manufacturing Rules I have made Layout for ARM processor. Work also with BGA footprint. I have done projects even on 10 layer. So I know how to build a layer stack up. As Layout and Schematic software I am an expert in Eagle, PADs, Zuken. As Simulation software for the Schematic I used LTSpice. If you want more information feel free to contact me.

Hi, You had given very less details about the project. if you can add more details to the project, we may give better proposal. consider to give outline requirements. if you needs microcontroller based or digital system, im really good on that.!, but if you need totally analog circuit, better look for someone else. but digital system with Analog inputs just fine for me.

Hi. Your description is a bit vague, However I am fully setup and capable of designing and building circuit boards. That's what I do! Please check out my profile. I can provide you with a circuit board design to offer as a solution for your project for your evaluation free of charge before end of this contest. I can email it to you, Please PM me. I am equipped to design and build a complete working prototype. I would need more information before I decide if I want to except the project, Best Regards, Lyndon Hammill, UK.