Custom PCIe4x board with Intel i350 ethernet controller
$750-1500 USD
Paid on delivery
I am looking for a skilled electronic engineer capable to design and prepare for production a PCIe x4 board with dual NIC controller Intel i350. The two SerDes interfaces of the i350 controller should be linked to two 400pin connectors. The 400pin connectors will be used to attach NVidia Jetson TX2 modules to the board. The Jetson TX2 modules will draw power from PCIe connector.
The goal of the project is to connect two NVidia Jetson TX2 modules to a x86 host. The host PC will recognize this board as a NIC card with two interfaces. The Jetson TX2 modules' ethernet ports will be 'hardwired' to the i350 NIC. Thus, the Jetson TX2 modules would be accessible to the host PC via LAN connecton.
Succesful bidder should have the datasheets to the components mentioned in this short project description to be able to discuss the scope of work.
Project ID: #17931844
About the project
9 freelancers are bidding on average $1441 for this job
Dear Sir, I am an highly skilled board designer who has over 17 years experience on complex, multi layers PCB design. I can provide you with service from schematic entry to PCB Layout.I can also provide the prototy More
Hi there , I am an electrical engineer with 19 years experience in this area. I am interested in your proejct Custom PCIe4x board with Intel i350 ethernet controller
Hi Sr, I can make the design that you need. I'm electronic engineer with more than 15 years of experience designing circuits. I know exactly what to do in this case when the high speed signals must to be carefull More
I am Excellent at the following: Embedded C Programming. Microcontroller like AVR, PIC and STM32. IDEs like Keil MDK V5, ATmel studio and MPLab XC8. IOT Technologies like Ethernet, GSM GPRS. HTTP Rest More
Hello I am an electrical engineer who have done a lot of software and hardware developments before. Your mentioned devices seem like somewhat new to people, but actually the device setup and embedded software developme More
I have a lot of professional experience in pcb designing. I have multiple finished pcb products. One of them is a 30+ layers pcb with Ethernet FPGA and a lo of things on it. I’ll give you finished product in two months More