Yes I am ready to Design transmitter and receiver set and i can start work now . I can design a PCB according to your sketch, dream, desire or something else.
I've done several mixed signal designs with SHARC and Blackfin DSPs at dynamic range up to 120dB.
I've worked on high speed designs with CV, A10, MAX10, PCIe Switch, DDR3/4, USB2.0/3.0, Ethernet up to 10G, SFP/SFP+/QSFP, ARM including STM32 and I.MX6.
I can estimate almost any dcdc from uA till 100A and I well know analogue electronics.
Electronics Design Engineer with a background in measurement systems.
I have a extensive experience in the development of electronic devices from initial idea to final product.
In my designs, I am ready to apply skills in analog and digital electronics including microcontrollers and FPGA.
My Technical Skills:
- Analog Circuit Design:
-- Measurement Circuits,
-- Power Supply Circuits,
-- A/D and D/A Converters,
-- Active and Passive Filters;
- Digital Circuit Design:
-- Microcontrollers,
-- FPGA,
-- Interface Buses (SPI, I2C, RS-232, RS-485, ...),
-- Memory Interfaces (DDR1-3, SDRAM, Serial/Parallel Flash, ...),
-- High Speed I/O Interfaces (USB, Ethernet, PCI Express, LVDS, ...);
- Multi-layer PCB Design:
-- BGA, Micro BGA, QFN, LGA, etc.,
-- Blind and Buried Vias,
-- Controlled Impedance Traces,
-- Differential Pairs,
-- Matched Length Traces,
-- Daisy Chain and Star Topologies;
- File Generation for a PCB Manufacturing Service (BOM, Gerber, NC Drill, Assembly Drawing, ...);