Electrical Engineer (Embedded, CAN BUS Experience)
min $50 USD / hour
We are looking for an electrical engineer who has embedded and/or CAN BUS (vehicle CAN networks such as J1850, J1939, etc.) experience to assist in identifying and reading messages (IDs) on vehicles we perform upfit and integration services on. This practice is allowed by both GM & Ford as we have already contacted them for best practices and approach. While they do not provide a list of the IDs needed, they support upfitters who can decode and use these messages (in a read only fashion) on their vehicles.
Technicians here can assist with grunt work of gathering data, we require guidance, validation and assistance in integrating these messages into our current J1939 based protocol system.
Additional work may include design of an interface gateway to move messages onto our control device BUS.
Attached are some background documents to further provide examples of what we are trying to do.
Initial vehicle shall be a Chevrolet Tahoe, decoding GMLAN messages for the following signals (read only into our J1939 network): Park, Brake, Reverse, Door Open (all), low beam headlights.
Project ID: #17831332
About the project
11 freelancers are bidding on average $54/hour for this job
Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in embedded design & programming using pic, dspic controllers and MATLAB codding fo More
Dear Sir, Thanks for sharing such an informative documents with your job description. I am an expert in embedded systems with more than 15 years of experience in design and development of embedded produc More
There is experience in designing an on-board computer and reading OBD data. Specify where you want to record the received data, form factor of the product, etc.
Electronics Engineer with experience in Microcontrollers and different bus protocols. Experience integrating Hardware with Software.
Hi, I worked on device tracking systems before, so you can trust me with your project. Br, Celil
Hi. What speed of bus? (kbod) Is it FR(FMR) or MR bus? Do you have logic analyzer? (simplest, like Saleae or similar)
I have very good experience in CAN Network, J1939 additionally my experience very relevant to the job description mentioned.