Electronic engineering problems help needed

Hello, I am a PhD candidate in Electrical Engineering (Control System). I have plenty of experience in firmware development and micro-controller developments. My Core Skills are: -MATLAB, SIMULINK MODLING AND SIMULATION - STM32F103C8T6 -ARM, DSP, MCUs, Arduino, Raspberry pi experiences. -Ardunio, Circut Design by the Altium, Eagle, PADs, 3D Models -Multi-Layer PCB design, -VHDL/Verilog HDL and FPGA. I can complete your project on time and you will satisfy if you hire me Best Regards: Aqeel Ahmed

I am DSP and control domain expertise I have controls domain expertise, and I am using MATLAB since 2012 I have 45 years of engineering design, and simulation experience also

Hi! I have understood your requirements about your project with every detail of it. I am an Electrical Engineer with more than 9 years of experience in electronics, circuit design, PCB layout, Verilog, FPGA, Embedded systems,microcontrollers, Proteus, Arduino, ESP32, Raspberry pi, NB-IoT, MATLAB, Algorithm, and Product design. I can assure satisfactory work. I'll be glad to work with you. Thanks

I graduated from the Faculty of Engineering. I followed electrical and telecommunications engineering. I have worked with jobs like this before. If you can give me a project, I can help to the best of my ability.

I am a mechatronics engineer, have sufficient experience in embedded systems, electronics, filters, and C/C++ programming, do not hesitate to send me soon.

Hi, there, I am an expert in matlab. I have a lot of experiences in many projects. We can discuss for your projects detail more. Best regards,

Hi, I am an Electrical Engineer and an expert in NI Multisim, Proteus and MATLAB. I have working experience in all these softwares. I can show the samples before starting the work. I have knowledge about oscillators using op_amp circuit and filters namely; pass band, band reject, high pass and low pass filters, including butterworth and chebyshev filters. I know the basics about these circuits, their roll off rate, gain and margin. Please do contact me to get your problem resolved perfectly. Thanks for hearing me out.

Hi I'm an electrical engineer with 03 years of experience in electrical engineering and matlab I have done many projects related to matlab and electrical engineering. I can help you in your work immediately

Hi I just see you need help in your project that is related to multisim simulation. I’m really interested in your project

Hello, for 10 years I have dedicated myself to electronic development, especially in audio equipment, filters and oscillators, which is what this branch of electronics also carries, I also have experience in simulation in multisimi and in LTspice

Hi there, I am Masters in Personal Mobile and Satellite Communication from University of Bradford, UK, So i can easily handle the product. Please contact me with details Thanks Regards, Usman