Here are the scenario and the issue that we are facing in our Cisco Router. We are using Cisco CSR 1000v Router Hosted in AWS.
We currently have two NAT setup done on our VPN router to allow internal to get outside.
ip nat Outside
ip address [login to view URL] [login to view URL]
ip nat inside
1st NAT Statement.
ip nat inside source static TCP [login to view URL] 2222 [login to view URL] 2222 extendable
This was done to bypass the router and SSH to the Linux server behind the router over SSH.
2nd NAT Statement.
This was done to allow internal to get outside..
ip access-list extended NATList
permit ip [login to view URL] 0.0.0.255 any
ip nat inside source list NATList interface GigabitEthernet1 overload
I am trying to set up an additional NAT translation 3rd one on this box which will pick up internal addresses, NAT overload them to the loopback0 interface before pushing it down an IPsec tunnel to a remote client network
Basically, I want all the traffic to be translated via Loopback0 interface.
Any expert available to solve this issue can ping me.
13 freelancers are bidding on average ₹6104 for this job
Hi Team, I am a network consultant with 12 years of experience. I have done many similar [login to view URL] skp I'd is [login to view URL], please feel free to contact me. Regards, Praseeth
Dear, Can i get a chance to troubleshoot your configuration and try to configure it to give you the desired functions. Please provide me with the whole configuration file if you accept me. Thanks