Update Building Plan

Need mark ups below corrected. Must follow 2018 North Carolina building codes. Note the garage and dwelling separation for the door, emergency egress for bedroom 3, identify the attic door type and thermal separation of the attic storage area from conditioned [login to view URL] the roof slopes in typically accepted format - provide required underlayment per R905.2 for asphalt roof slopes between two units vertical in 12 units horizontal up to four units vertical in 12 units horizontal. Stair is shown as access to attic - detail the design of the stair with riser and tread sizes and guardrail, and indicate location of access to remainder of attic. Indicate the lumber species and grade for structural members, ceiling joists indicated exceed maximum allowed spans - revise or engineer, note the maximum span for the roof rafters meeting span tables or engineer, detail the wall construction; detail the attic floor structural design and supports, note the header sizes, details on sheet A09 reference general notes not found - provide general structural notes including design loads, wind loads, and other required structural design notes. ote the wall bracing method. Indicate the required slope for the garage floor [login to view URL] six on sheet A00 indicates plans not to be used for construction unless so marked - no mark found - note the plans for permit and [login to view URL] the thermal insulation values for the building envelope ceiling, walls, floors, and fenestrations following the requirements of Table N1102.1 and include whether the values are minimums or maximums