Building 5000V, 100KHz+200KHz, 10W sine wave generator.

Hi, I would be glad to work with you to complete this project. Can you send me more details about the load that will be connected to this inverter? Best regards,

Dear Sir, I am an embedded systems expert with more than 15 years of experience in Firmware development, Prototyping and PCB Layouts. I have worked with 16-bit and 32-bit architectures developing ultra-low power designs with complex computations. I have worked in Smart Grid, automotive and Communications. I have checked the details of your work and assure you the best solution for you design. Lets discuss Regards Talha

Hi. I am very interested in your project. i have rich experience on PCB design and firmware. I think this project is very suitable for me and i am sure i can give you good result . If you award me for your project, you will get good result . please call me.

Hello Dear Concern, We are a team of professional members of Electrical, Electronics, Mechanical, Civil, Chemical Engineering. We are also expert in following softwares: MATLAB, Simulink, PADS, PORTEL,Proteus, Cadence ,Solidworks PCB, ANSYS, ABACUS, AUTOCAD, DipTrace, Kidcad, MATLAB, SPSS, PRO/E, CATIA V5, Stud pro, Homer Pro, We are trusted people and will never break you trust. We will deliver your work with in your defined timeline. I assure you that your work will be error free and 100% professional with high quality. We will never waste your time and money. We will try over best to make you proud. Please consider me for this job. Thank you in advance. Regards,

Hello, I'm an Electrical Engineer .I have many Experiences in Microcontroller, Arduino , sensors ,PLC’s, SCADA system, circuit design , PCB ,also I have experience in programming that connect electronic to desktop application , android application , and ios

I am hard working, fast to learn and easily adopt to new ideas. I am data analysis and have good communication skills.

hi sir I am electrical engineer my graduation project was about VSC HVDC and DCCB simulation by Matlab so I have experience in inverters so don't hesitate and call me

I am interested to work as freelancer and I have the experience on all commercial,RF, Power boards and ATE boards. I have 10+years of experience in allegro and altium tools

I am an Electronic engineer with years of experience in hardware and embedded system Design. I hope we could work together in this project